Running `upspinserver` on Ubuntu 16.04

These instructions are part of the instructions for Setting up upspinserver. Please make sure you have read that document first.

Introduction

These instructions assume you have access to an Debian or Ubuntu linux server, and that the server is reachable at your chosen host name. (upspin.example.com)

Note that these instructions have been verified to work against Ubuntu 16.04. The exact commands may differ on your system.

Once the server is running you should log in to it as root and configure it to run the appropriate upspinserver by following these instructions.

Create a user

Throughout this document, we will mark commands to be run on your local machine with the shell prompt local$ and commands to be run on your server with server%, or if running as root, server#.

The following commands must be executed on the server as the super user, root, perhaps via sudo su.

Create a Unix account named upspin:

server# useradd -m upspin

Give yourself SSH access to the upspin account on the server (a convenience):

server# su upspin
server% cd $HOME
server% mkdir .ssh
server% chmod 0700 .ssh
server% cat > .ssh/authorized_keys
(Paste your SSH public key here and type Control-D and Enter)
server% chmod 0600 .ssh/authorized_keys

Create the letsencrypt cache directory:

server% mkdir -p upspin/letsencrypt

Copy the `upspinserver` binary to the server

When following the setup instructions you built an upspinserver server binary appropriate for your chosen storage technology (local disk or a cloud storage provider).

The binary may be named upspinserver or have a cloud service suffix, as with upspinserver-gcp. When we copy the binary we always install it as simply upspinserver so the subsequent instructions are the same for all configurations.

From your workstation, copy the binary to the server (substitute the name of your binary for upspinserver-foo):

local$ scp upspinserver-foo upspin@upspin.example.com:upspinserver

Run `upspinserver` on server startup

The following commands must be executed on the server as the super user, root.

These instructions assume that your Linux server is running systemd.

Create the file /etc/systemd/system/upspinserver.service that contains the following service definition.

[Unit]
Description=Upspin server

[Service]
ExecStart=/home/upspin/upspinserver
User=upspin
Group=upspin
Restart=on-failure

[Install]
WantedBy=multi-user.target

Allow `upspinserver` to listen on ports `80` and `443`

The upspinserver binary needs to listen on ports 80 and 443 in order to obtain its TLS certificates through LetsEncrypt.

Normally only user root can bind ports below 1024. Instead of running upspinserver as root (which is generally discouraged), we will grant the upspinserver binary this capability by using setcap (as root):

server# setcap cap_net_bind_service=+ep /home/upspin/upspinserver

Note that you need to run this setcap command whenever the upspinserver binary is updated.

Start the service

Use systemctl to enable and start the service:

server# systemctl enable --now /etc/systemd/system/upspinserver.service

You may also use systemctl stop upspinserver and systemctl restart upspinserver to stop and restart the server, respectively.

You can use journalctl to see the log output of the server:

server# journalctl -f -u upspinserver

Continue

You can now continue following the instructions in Setting up upspinserver.

Running upspinserver on Ubuntu 16.04